The Colour Forge - Matt Varnish Spray
The Colour Forge Matt Varnish spray delivers exactly what it promises – a truly flat, protective finish for your miniatures.
This high-quality varnish has been rigorously tested over various finishes including satin varnish, gloss varnish, and standard paints, delivering consistently impressive results.
If you need to eliminate shine and protect your paintwork with a durable, genuinely matt seal, you won't be disappointed with this product.
Get more with the generous 500ml spray can – that's 25% more product than many standard brands!
For the Best Results:
-
Shake Well: Shake the can vigorously for at least 2 minutes to ensure the contents are fully mixed. You should hear the agitator ball moving freely.
-
Warm Gently: If the can feels cold, stand it in a container of warm (not hot!) water for a few minutes. Keep the water level below the nozzle area. This improves spray consistency, especially in cooler conditions.
-
Test Spray: Briefly spray onto a piece of scrap material to ensure an even, non-spluttering flow.
-
Apply: Hold the can approximately 15-25 cm (6-10 inches) away from the model. Apply using short, light, even passes, moving across the model. It is crucial to apply thin coats; multiple thin coats are always better than one thick coat, which can obscure detail or cause frosting. Allow sufficient drying time between coats as recommended by the manufacturer (check can if specific time is listed).
-
Clear Nozzle: After use, turn the can upside down and spray for a few seconds until only clear propellant comes out. This helps prevent nozzle blockages for next time.
Safety Information:
-
Not suitable for children under 36 months. Keep out of the reach of children.
-
Danger! Extremely flammable aerosol. Pressurized container: May burst if heated.
-
Keep away from heat, hot surfaces, sparks, open flames, and other ignition sources. No smoking.
-
Do not spray on an open flame or other ignition source.
-
Do not pierce or burn, even after use. Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F.
-
Causes serious eye irritation. May cause drowsiness or dizziness. Repeated exposure may cause skin dryness or cracking.
-
Use only outdoors or in a well-ventilated area. Avoid breathing vapor/spray.
-
Wear protective gloves/protective clothing/eye protection/face protection.
-
IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.
-
Dispose of contents/container in accordance with local regulations.
Senest set